www.fisher-price.com
K7273
Please keep this instruction
sheet for future reference,
as it contains important
information.
Requires three “AA”
batteries (included).
Adult assembly is required.
Tool required for assembly:
Phillips screwdriver
(not included).
Musical
Learning
Chair
™
with activity table
Before Use Parts
Please keep small parts such as plastic tabs out
of children’s reach. Throw the plastic tab away.
Note: A plastic tab is attached to the toy for in-store demonstra-
tion purposes. While the tab may have already been removed,
check the chair bottom to be sure. If the plastic tab is still
attached, pull and remove the tab from the toy. Throw the plastic
tab away.
CAUTION
4 Legs
Seat Bottom
Seat Back
Table Base
Table Top
3.5mm x 18mm Screw – 10
Shown Actual Size
Note: Tighten or loosen all screws
with a Phillips screwdriver.
Do not over-tighten the screws.
Plastic Connector
Assembly
Seat Back
Seat Bottom
• Fit the seat back into the seat bottom, as shown.
1
• Position the chair assembly so the bottom is facing you.
• Insert two screws into the chair bottom. Tighten the screws.
• Fit the four legs to the chair bottom, as shown.
Note: Each leg fits in only one location.
• Insert a screw into each leg. Tighten the screws.
This toy contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION
1
2
3
Assembly
• Locate the connector coming from
underside of the chair bottom.
• Insert the connector into the socket
on the table base, as shown.
• Turn the assembly upright.
• Press down firmly to “snap” the table top onto the table base.
Note: This may require some force.
• Insert two screws through the table base and into the leg.
Tighten the screws.
• Slide the table base onto the chair assembly, as shown.
Table Base
Socket
Connector
4
5
1
6
7
Table Top
Assembly
1
• Turn the table top left, towards the seat back, as far as it will go.
Hint: You may need to hold the table top in this position for
the next two assembly steps (10 and 11).
1
• Locate the connector coming from the table base.
• Insert and “snap” the connector into the socket on the underside
of the table top.
• Tuck the excess wire from the connector back down into the
opening in the table base.
Socket
Connector
Back View
8
9
Table Top
1
• Fit the plastic connector to the back of the table and in front of
the seat back.
Note: Make sure the plastic connector is in front of the seat back.
10
Plastic
Connector
1
• Align the holes in the plastic connector with the holes in the
table. Insert two screws into the plastic connector and tighten.
Assembly is now complete.
11
Table
Seat Back
Battery Replacement
FCC Statement
For best performance, we recommend replacing the
batteries that came with this toy with three, new alkaline
“AA” (LR6) batteries.
• Locate the battery compartment on the underside of the chair.
• Loosen the screw in the battery compartment door. Remove the
battery compartment door. Remove the batteries and throw
them away.
• Insert three “AA” (LR6) alkaline batteries, as indicated inside the
battery compartment.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten the screw.
• When lights or sounds from this toy become faint or stop,
it’s time for an adult to change the batteries!
1.5V x 3
“AA” (LR6)
Shown Actual Size
Battery Compartment Door
Care
• Wipe this toy with a clean cloth dampened with a mild soap
and water solution. Do not immerse this toy.
• This toy has no consumer serviceable parts. Do not take this
toy apart.
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to
be charged under adult supervision.
Battery Safety Information
United States Only
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
• Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities (Europe only).
• Locate the mode switch on
the armrest.
• Slide the mode switch to either
learning mode or music
mode .
• When your child is finished playing
with this toy, slide the mode switch
off
o
.
• Locate the volume switch on the
underside of the chair.
• Adjust the volume to high
or
low
, for your child’s comfort.
Learning Mode Music Mode
Press down on the lamp
• Sit on the “magic” seat to hear the A-B-C song.
• Turn the book pages to learn about each animal and hear the
sound it makes.
• Turn the clock hands to hear a fun counting song.
• Press down on the lamp to light up colored lights and learn
about on and off.
• Sit on the “magic” seat to hear a song. Stand up to stop the
song. Sit down to resume.
• Turn the book pages to hear a song and sound effect for
each animal.
• Turn the clock hands to hear Hickory Dickory Dock.
• Press down on the lamp to light up colored lights and hear
a short ditty.
Mode Switch
Volume Switch
Turn the pages in the book
Sit on the seat
Turn the clock hands
Two Interactive Play Modes!
ABC
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A. K7273pr-0920
©2006 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
Make learning more fun with the whole collection of Laugh & Learn
™
toys. With rich music, lyrics and lots of activities,
they combine early academics and everyday experiences, for the way kids really learn.
Each sold separately and subject to availability.
Consumer Information
Learn every day - through fun, familiar play!
G6685 G6167C6327 C6324
C6325 C5522
G9452
C6513
Visit us on-line at www.service.fisher-price.com
Call Fisher-Price
®
Consumer Relations, toll-free at 1-800-432-5437, 9 AM - 7 PM EST Monday through Friday and
11 AM-7 PM EST Saturday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470.
Write to us at: Fisher-Price
®
Consumer Relations, 636 Girard Avenue, East Aurora, New York 14052.
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2; www.service.mattel.com
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303; www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
H6372 J2462 J4013
