Fitting Instructions for Roman Blinds
Step 1
Outside Recess
If the blind is to be fitted outside the window, ensure that measurement C is
the same. C is simply equal to A minus B, divided by two. Follow instructions
for FACE FIXING.
Inside Recess
If TOP FIXING, fix to the lintel if the window is uPVC, or if there are no
obstructions. If FACE FIXING, fit bracket to window frame.
Step 2
Place bracket into position 5cm from clutch end of the blind and 5cm from the other end.
Brackets should then be positioned either side of the lifting cords/cones.
B: Bracket Locations
M: Clutch Mechanism
C: Cone Position
E: End Cap
Step 3
Top Fixing
Measure and mark the distance (D),
allowing for any obstructions (handles)
that protrude into the recess area.
Fix the bracket into
position using the fixing holes.
Face Fixing – Standard Bracket
Affix bracket using fixing holes as shown below.
For more information or help with fitting your blind please call +44 (0) 28 9266 3600 or email [email protected]
Step 4
Fitting the Blind
Angle headrail to fit onto catches
at bottom of bracket at ‘A’
Rotate front of headrail up
compressing springs until top lip
clicks into place at ‘B’
Removing the blind
For each bracket, starting from one end of the blind:
1) Press the headrail up compressing the spring
2) Tilt the headrail down at the front, to clear
3) Unhock from the bottom rear catches
4) Repeat for the next bracket, ensuring that the headrail
is adequately supported at the free end
D
Top Fix - Fixing Holes
A
B
the top rear catches
B B
B B
C
C
C
EM
WARNING
Young children can strangle in the loop of pull cords, chains, tapes that operate window coverings. They can
also wrap the cords around their necks. To avoid the risk of strangulation and entanglement, keep cords out
of the reach of young children. Move beds, cots and furniture away from window covering cords.
